Weld-in Frame Bulkhead Plates

Squeeg’s offers its own design of bulkhead plates for use in any frame.

 

Choose from either a blank plate or with terminals.

 

The weld-in plate consists of ¼ 1018 steel and is milled to accept a precision fitted cap. Offered in an oval or round design, these plates will allow you to run your plumbing or electrical through your frame rails.

 

The electrical plate consists of two nylon insulated terminals with brass inserts. The small terminal is tapped at 10/32 and the large is at ¼ 20. This is ideal for running electrical to the starter.

 

We also offer a blank plate which can be drilled for AN bulkhead fitting for plumbing or any other use you may need.

PlateDisplay.jpg
BHOP-B Front.JPG
BHOP-T Front.JPG
BHRP-B Front.JPG
BHRP-T Front.JPG
Blank Oval Weld in Bulkhead Plate With Two Lines
Blank Oval Weld In Bulkhead Plate With Four Lines
Oval Weld in Bulkhead Plate with Terminals
Oval Weld in Bulkhead Plate with Terminals
Blank Oval Weld In Bulkhead Plate With Two Lines

#3AN Bulkhead Mount

Squeeg's Hot Rod Connection #3AN Bulkhead Mount

Also Available From...

So-Cal AZ.png

Dealer Inquiries Invited

Squeeg’s offers #3AN bulkhead mount designed to fasten to your frame or any other component of your car.

Simply secure your #3 bulkhead fitting and easily attach a hard line to a flex line. Ideal to use instead of a through frame fitting for front and rear brake lines.

#3AN Bulkhead Mount With Brake Lines
#3AN Bulkhead Mount With Brake Lines
Prop 65 1x4 Flat.jpg

Squeeg's Kustoms

  • Facebook - Grey Circle
  • Instagram - Grey Circle

© 2019 Squeeg's Kustoms

All Rights Reserved

Squeeg's Hot Rod Connection

  • Facebook - Grey Circle
  • Instagram - Grey Circle