Squeeg’s Kustoms Epoxy Primer Filler
Squeeg’s epoxy primer filler is a 2 part catalyzed system. 

Is designed to go over:

• All types of bare metal, including steel, aluminum, stainless steel, brass, magnesium
• Carbon fiber, fiber glass, smc
• NOT TO BE USED OVER PLASTIC OR RUBBER

Advantages:

• When applied as a primer surfacer, the advantages are HIGH BUILD and NO SHRINKING when used to block sand
• UNMIXED COMPONENTS WILL KEEP INDEFINITLEY IF LIDS ARE REPLACED TIGHTLY AFTER USE
• When primer is applied correctly as a sealer, metals  WILL NOT corrode
• Primer can be used as a filler, up to ready for wet sand
• To paint, NO SEALER is required on top of it, surface must be sanded with at least 600 grit or coarser
• When used as a sealer, it’s recommended that all body filler be applied on top of primer when cured

All automotive manufacture paint material’s
are compatible as a top coat.
Because, when Squeeg’s Kustoms Primer is fully cured the surface is a hard durable epoxy finish.

Squeeg’s Kustoms has personally been using this primer for the past 18 years and has experienced no problems

With the hot surface temperature in Arizona, we need a high build product that won’t shrink.

OVERVIEW

• These directions are provided to assist you with the proper application of your primer coats. Following these directions will yield excellent results.  As you should know, a GREAT surface is a Great paint job.  DO NOT TAKE SHORT CUTS.

Prepping all metals:

• All surfaces MUST be cleaned of wax, grease, oil, etc.
• Must be machine or hand sanded to 80 grit, make sure entire surface being primered is sanded to look like new metal, no contaminates should be present
• Clean all welds with grinder and or wire wheel
• Wipe clean with Squeeg’s Epoxy Thinner/ Reducer or acetone (DO NOT TOUCH SURFACE WITH BARE HANDS, oil from hands will contaminate the surface)

Prepping fiberglass:

• All surfaces must be cleaned of wax, grease, oil, etc.
• Must be machine or hand sanded to 80 grit
• Blow off surface (DO NOT TOUCH SURFACE WITH BARE HANDS, oil from hands will contaminate the surface)

Directions of use:

• Squeeg’s epoxy primer filler is a 2 part catalyzed system. It consists of component A and B
• Mix each component separately and thoroughly until all pigment and clumps are dissolved (shaking, mixing machine, hand stir, etc.)
• A and B component should be blended 50/50 (1:1 ratio) by volume
• After components are mixed thoroughly, allow mixture to set 30 minutes for induction period
• STRAIN mixture into spray gun
• To seal metals: apply 2 coats allowing it to flash in between (flash is when surface looks dull and not wet), allow 24 hours to cure
• Warmer temperatures will shorten cure time
• Sand surface with 80 grit by hand or machine
• Apply body fillers up to finishing body work (make sure body work is finished with 80 grit or finer)
• (if applying over fiberglass type surface, start applying as a filler for block sanding)
• After body work is finished apply up to 5 coats, letting flash between coats
• Let cure 24 to 48 hours depending on conditions
• After cured you’re able to block sand

Squeeg’s Primer Filler is NOT designed for production use, it is used as a high build, epoxy primer for the most durable primer coat available.

MUST USE RESPIRATOR TO SPRAY OR DRY SAND